Select Languages

Properties

• Can be used on all kinds of rough surfaces.
• Fills gaps in worn out joints
• Fits bearings, prevents the dislocation.
• Fills smallest gaps due to its low viscosity and is used in sensitive fittings.
• Fits impellers and shafts together.
• Locks linings and boots to their beds and on the shaft.

Applications Area

• Clean male and female threads before assembly with an absorbent tissue paper to remove any cutting oil.
• Apply the adhesive with a 360 turn to leading threads of the male and female fittings.
• Use an absorbent tissue paper to wipe off excess jointing compound in the direction of the thread.
• Assembly parts and hold on for 24 hours at 22-24°C to ensure full curing of jointing compound.
• For disassembly, use hand tools to remove mating parts. When it is hard to dissemble at room temperature, apply local heat until reaching 250°C and disassemble while hot. Then, remove any residual cured adhesive mechanically and clean parts with a proper solvent, acetone.

Package